Abbotsford By-law 3066, s. 21(a) — Street and Traffic Bylaw, 2021

the permit holder must place a pipeline crossing installation by drilling or jacking in such a manner as to afford minimum grade settlement;

• (b) the permit holder must not use water jetting;
• (c) the general manager may authorize an excavation for a pipeline crossing installation if, in the opinion of the general manager, the excavation is not detrimental to a highway or a user of the highway;
• (d) the permit holder must not use an open cut for a pipeline installation on a highway or a newly constructed road, unless an alternative does not exist and the permit holder provides compensation to the City in an amount satisfactory to the general manager;
• (e) the permit holder must case or embed a pipeline of non-rigid material, including plastic or copper, in sand;
• (f) the permit holder must ensure that the inside diameter of a casing pipe is at least 25% larger than the outside diameter of the pipeline;
• (g) the permit holder must install a casing pipe with an even bearing throughout its length and in such a manner that prevents leakage, except leakage that occurs through a vent;
• (h) the permit holder must ensure that a top of the casing pipe or the pipeline where casing is not required
• (i) is located as directed by the general manager,
• (ii) is not less than 1.2 metres below the surface of a highway, and
• (iii) is not less than 0.75 metres below a highway ditch;
• (i) the permit holder must ensure that the pipeline does not interfere with
• (i) traffic on a highway, or
• (ii) maintenance of a highway. PART 3 - HIGHWAY TRAFFIC CONTROL REGULATIONS Division 1 - Delegated Powers Removal of vehicles 22 (1) The general manager may remove, detain or impound a vehicle that unlawfully occupies

a portion of a highway or a public place.